Philips TS3661C1 manual Setting the Remote Control to Work with Other Devices

SETTING THE REMOTE CONTROL TO WORK WITH OTHER DEVICES
Direct Access Method
ow that you have looked up
Nthe three-digit Remote Code								2
Number for your brand of device,
you are ready to follow the four		1			SLEEP
simple steps below.
Please read through steps 1-4					A/CH	STATUS/EXIT	CC	CLOCK
									4
before beginning.				TV	RECORD			TV/VCR
BEGIN				VCR	1	2		3
Place the TV/VCR/ACC				ACC
				3	4	5		6
Mode Switch in the proper posi-
tion.					7	8		9
Press the VCR RECORD
					SMART			SMART
button on the remote control and	VCR					0
release.								PICTURE
					SOUND
Press the SmartSound button					MENU			SURF
on the remote within 30 seconds,
then release.
Enter the THREE-DIGIT	Satellite Receiver
	or DBS, etc.
REMOTE CODE NUMBER
for your desired device. The
remote is now ready to send					VOL			CH
commands to the unit.						MUTE
Point the remote at the	Cable Converter
Device. Press the POWER button
on the remote to turn the unit
ON.
SMART HELP				5
Remember, if this doesn’t		POWER
	SLEEP	CLOCK
		CC
		ATUS/EXIT
work the first time, repeat steps	A/CH	TV/VCR
	RECORD
	TV
	VCR
using the same remote code number.		ACC
			SMART
		SMART	PICTURE
		SOUND		SURF
After a second try and the remote		MENU
does not operate your device, see if				CH
			VOL	MUTE
there is another three-digit code num-
ber (pages 33-34) listed for your
device and repeat the steps above
using the new number.
If after repeated attempts the code
number method does not work you
device, try the SEARCH METHOD
on page 32.
		31