Philips TS2779C1 manual Press the Power button on the device your are attempting to

SETTING THE REMOTE CONTROL TO WORK WITH OTHER DEVICES

Search Method

Your TV remote can be set to work various external devices

such as VCRs, Cable Boxes, Satellite Receivers, DBS, etc. by what is called the search method of remote control programming. If the “DIRECT ACCESS” code number method (shown on the previous page) did not set your remote to work your accessory device, then follow the easy steps listed below.

Note: The Search Method only works with devices equipped with channel display indicators or capability.

Please read steps 1-4 before begin- ning.

BEGIN

Press the POWER button on the device your are attempting to

program to turn it ON.

Place the TV/VCR/ACC Mode Switch in the proper posi-

tion.

Press the (A/CH) • RECORD and the SMART SOUND but-

tons simultaneously and hold them down.

The device will begin to change channels after the remote identi-

fies the correct code. When the channels start to change release the VCR RECORD and SMART SOUND buttons. The remote should be ready to operate the device.

Satellite Receiver

Cable Converter		070809 06			07
1
					0809
		06		0708
VCR				09
				POWER	4
2	SLEEP
	A/CH	STATUS/EXIT	CC	CLOCK
TV	RECORD			TV/VCR
VCR	1	2		3
ACC				3
	4	5
	7	8		9
	SMART			SMART
		0
	SOUND			PICTURE
	MENU			SURF
3
	VOL			CH
		MUTE

SMART HELP

This method can take up to

two minutes to perform.

Don’t let the device scan up more than five channels. If you do the remote may pass up the right code and another two minute search cycle will have to be repeated.

If no channel change happens within two minutes, repeat steps 1-4. Should a channel change still not occur, the remote will not work the desired device.

32