BDL3220QL
Polish Center for Testing and Certification Notice
The equipment should draw power from a socket with an attached protection circuit (a
The phasing conductor of the room’s electrical installation should have a reserve
To completely switch off the equipment, the power supply cable must be removed from the power supply socket, which should be located near the equipment and easily accessible.
A protection mark “B” confirms that the equipment is in compliance with the protection usage requirements of standards
Information for U.K. only
WARNING – THIS APPLIANCE MUST BE EARTHED.
Important: |
(B) |
(A) |
This apparatus is supplied with an approved moulded 13A plug.To change a fuse in this type of plug proceed as follows:
1.Remove fuse cover and fuse.
2.Fit new fuse which should be a BS 1362 5A,A.S.T.A. or BSI approved type.
3.Refit the fuse cover.
If the fitted plug is not suitable for your socket outlets, it should be cut off and an appropriate
If the mains plug contains a fuse, this should have a value of 5A. If a plug without a fuse is used, the fuse at the distribution board should not be greater than 5A.
NOTE: The severed plug must be destroyed to avoid a possible shock hazard should it be inserted into a 13A socket elsewhere.
How to connect a plug
Electric, Magnetic and Electronmagnetic Fields (“EMF”)
1.We manufacture and sell many products targeted at consumers, which, like any electronic apparatus, in general have the ability to emit and receive electromagnetic signals.
2.One of our leading Business Principles is to take all necessary health and safety measures for our products, to comply with all applicable legal requirements and to stay well within the EMF standards applicable at the time of producing the products.
3.We are committed to develop, produce and market products that cause no adverse health effects.
4.We confirm that if its products are handled properly for their intended use, they are safe to use according to scientific evidence available today.
5.We play an active role in the development of international EMF and safety standards, enabling us to anticipate further developments in standardization for early integration in its products.
The wires in the mains lead are coloured in accordance with the following code:
BLUE – “NEUTRAL” (“N”) BROWN – “LIVE” (“L”)
GREEN & YELLOW – “EARTH” (“E”)
1.The GREEN & YELLOW wire must be connected to the terminal in the plug which is marked with the letter “E” or by the Earth symbol or coloured GREEN or GREEN & YELLOW.
2.The BLUE wire must be connected to the terminal which is marked with the letter “N” or coloured BLACK.
3.The BROWN wire must be connected to the terminal which marked with the letter “L” or coloured RED.
Before replacing the plug cover, make certain that the cord grip is clamped over the sheath of the lead – not simply over the three wires.
v