Access decoder channel
You can map channels provided through a decoder or descrambler to yourTV channel selection. In this way, you can select these channels by using the RC of yourTV.The decoder or a descrambler must be connected to EXT1 or EXT2.
Set decoder channel
Map channels from a decoder or descrambler
1Press 
MENU.
2Select [Installation] > [Decoder] .
3Press 
to enter [Decoder].
4Press 
to enter [Channel].
5Press 
to select channel number to map to the decoder/descrambler channel.
6Press OK.
7 Press | to select and enter [Status]. |
8Press 
to select the connector used by the decoder/descrambler ([None], [EXT 1] or [EXT 2] .
9Press OK.
10 Press 
MENU to exit.
Note
•Select [None] if you do not want to map to the decoder/descrambler channel.
•[EXT 2] is available only in TVs of 26 inches and larger.
Start a TV demo
1 | Press MENU. | English |
2 | Select [Features] > [Demo] . |
|
| » The [Demo] menu appears. |
|
3 Press 
to select a demo.
•[Dig.CrystalClear]Digitally adjusts picture quality to optimal contrast, colour and sharpness.
•[Active Control]Automatically adjusts the picture setting for optimal picture quality continuously under any signal conditions.
4Press OK to start the demo.
5Press 
MENU to exit.
Reset the TV to factory settings
You can restore the default picture and sound settings of yourTV. Channel installation settings remain the same.
1 Press 
MENU.
2Select [Installation] > [Factory settings] .
3 Press 
to enter the [Factory settings] menu.
»[Reset] is highlighted.
4Press OK to reset to factory settings.
5Press 
MENU to exit.
EN 17