Philips 42HF7543 ∙ Welcome Message, ∙ Power on Standby / Forced on, Volume Indicator, Digit Entry

2005 HF Series User’s Manual	112505.0959
	SWITCH ON / OSD
	SWITCH ON / OSD
WELCOME MESSAGE	>
SWITCH ON CHANNEL	TV 2
SWITCH ON VOLUME	30
SWITCH ON PIC FMT	WIDESCREEN
POWER ON	STANDBY
VOLUME INDICATOR	YES
CHANNEL DISPLAY	ALL
3 DIGIT ENTRY	NO

∙WELCOME MESSAGE:

A welcome message (two lines, 20 characters) can appear on-screen when the set is powered on. The message remains on-screen until the TV receives a command from the remote or front panel or times out in 25 seconds. When the WELCOME MESSAGE setup menu item is highlighted, cursor right or left to invoke the MESSAGE sub- menu. Cursor up or down to select the desired MESSAGE sub- menu item. Press MENU to return to the SETUP main menu.

∙SWITCH ON CHANNEL: TV 1-TV 125/HDMI 1/HDMI 2/SIDE AV/AV 1/AV 2/ / STANDARD)

Specify the channel / input to which the TV will be tuned when it is powered on. If STANDARD, the channel at power-on will be that to which the TV was tuned at last power-down. If specified (e.g., 2, AV1, etc.), then that will always be the channel / input at power-on, until SWITCH ON CHANNEL is changed.

∙ SWITCH ON VOLUME:(STANDARD / 0 - 99) Specify the volume setting that takes effect when the TV is powered on.

If STANDARD, the volume at power-on will be the volume at which the TV was prior to last power-down.

If specified as 0 - 99, that will always be the volume at power-on, until SWITCH ON VOLUME is changed.

∙ POWER ON:	(STANDBY / FORCED ON)
STANDBY:	The TV will be in standby mode when AC mains power is first
applied after having been disconnected.
FORCED ON:	The TV will turn ON whenever AC mains power is applied. This
feature allows the TV’s power status to be controlled, for example, from an AC mains
breaker. In addition, the set cannot be put into standby with a guest remote or using
the front panel power key.

∙	VOLUME INDICATOR:	(NO / YES)
	When VOLUME INDICATOR is set to YES, an OSD graphic appears that provides
	visual verification (e.g. “VOLUME 15”) during volume adjustment, by means of
	either the remote control, or the front panel (if it is not locked out).
∙	CHANNEL DISPLAY:	(NONE / NUMBER / LABEL / ALL)
	Specifies which of the respective channel properties are displayed by the TV’s OSD
	when a channel or input is first selected.
∙	3 DIGIT ENTRY:	(NO / YES)

oYES: The TV, upon receiving a remote control digit command, “expects” to receive up to two more successive remote control digit commands (e.g. 123, 012, etc.) before tuning the intended channel. The television will display, in

12