6 Quick Installation
When you switch on the TV set for the first time, a menu is displayed on screen. This menu prompts you to select the country of your choice.
Country
B | Press OK |
CH | to continue |
D |
|
DK |
|
E |
|
F
FI
GB
Note: If the above menu is not displayed, proceed to do the installation of channels by the Auto Store method (see page 9). If above menu is displayed, proceed to the following steps:
Press the Î ï keys on the remote control to select your country. If your
country does not appear in the list, select “. . . “ . Refer to the “Reference
table of countries” on page 33.
1.Press the Æ / 
key to select the language mode.
2.Select your language by using the Î ï keys.
Language
English | Press OK |
Dansk | to continue |
Nederlands |
|
Suomi |
|
Français |
|
Deutsch |
|
Eλληνικα |
|
Italiano |
|
3. Press the Æ / 
key to start search.
The search starts automatically. All the available TV programmes will be stored. This operation takes a few minutes.
The display shows the progress of the search and the number of programmes found.
Important : To exit or interrupt the search before it is completed, press the menu key. If you interrupt search during auto store, not all channels will be stored. To store all channels, you must perform a complete auto store search again.
ATS (Automatic Tuning System)
If the transmitter or cable network sends the automatic sort signal, the programmes are numbered correctly. In this case, the installation is complete.
If the transmitter or cable network does not send the automatic sort signal, the programmes are not numbered correctly. You can use the Sort menu to number the programmes.
ACI (Automatic Channel Installa- tion)
If a cable system or a TV channel which broadcasts ACI is detected, a programme list appears. Without ACI broadcast, the channels are numbered according to your language and country selection. You can use the Sort menu to renumber the channels.
Downloaded From