Philips 26PFL3405/12 Change TV preferences, Access decoder channel, Set decoder channel

Page 22

Disconnect a USB storage device

Caution

•Follow this procedure to avoid damage to your USB storage device.

1 Wait for ﬁve seconds before you disconnect the USB storage device.

Change TV preferences

Use the preferences menu to customise your TV settings.

1Press MENU.

2 Press to select [Installation] >

[Preferences].

•[Volume bar]: Displays the volume bar when you adjust the volume.

•[EasyLink]: Enables one-touch play and one-touch standby between EasyLink-compliant devices.

3 Press

to select your preference.

4Press OK.

5Press MENU to exit.

Access decoder channel

You can map channels provided through a decoder or descrambler to yourTV channel selection. In this way, you can select these channels by using the RC of yourTV.The decoder or a descrambler must be connected to EXT 1 (SCART).

Set decoder channel

Map channels from a decoder or descrambler.

1Press MENU.

2 Press	to select [Installation] >
[Decoder].

3Press to enter [Decoder] menu.

4Press to select [Channel], then press

to enter.

5Select one channel to map to the decoder / descrambler channel and press OK to conﬁrm.

6Select [Status], then press to enter.

7Select [EXT 1] (SCART), the connector used by the decoder / descrambler.

8Press OK.

9Press MENU to exit.

Note

•Select [None] if you do not want to map to the decoder / descrambler channel.

Reset the TV to factory settings

You can restore the default picture and sound settings of yourTV.The channel installation settings remain the same.

1Press MENU.

2 Press to select [Installation] >

[Factory settings].

3Press to enter [Factory settings].

4Select [Reset] to start resetting.

5Press OK.

6Press MENU to exit.

20EN

Image 22

Contents Page Clientes en España Contents Koninklijke Philips Electronics N.V.All rights reserved English Safety Screen care Disposal of your old product and batteriesHigh energy efﬁciency Low standby power ECO-GreenSide controls and indicators Your TVRemote control Remote control usage Switch channels with the channel grid Switch your TV on / off or to standby Switch channelsUse your TV Watch connected devices Adjust TV volumeUse the source button Use more of your TV Access TV menusChange picture and sound settings Use smart pictureManually adjust picture settings Summary of picture formats Change picture formatUse smart sound Access the teletext options menu Use advanced teletext featuresManually adjust sound settings Select teletext subpagesView all channels Select T.O.P. teletext broadcastsSelect a favourite list Add a channel to a favourite listUse timers Use the TV clockSet or change your PIN code Automatically switch the TV on on timerUse TV locks Lock or unlock the TVLock or unlock one or more channels Update the TV softwareUpdate using a USB device Check the current software versionChange TV preferences Access decoder channelReset the TV to factory settings Disconnect a USB storage deviceAutomatically install channels Install channelsManually install channels Fine-tune analogue channels Search and store new TV channelsSkip channels Rename channels Rearrange channelsBack connectors Connect devicesTV Antenna Signal input from an antenna, cable or satellite Side connectors Connect a computer Use a Kensington lock Enable or disable EasyLinkUse Philips EasyLink Use one-touch playTuner / Reception Transmission Supported display resolutionsPower Supported TV mountsProduct speciﬁcation TV channel issues TroubleshootingGeneral TV issues Picture issuesComputer connection issues Sound issuesHdmi connection issues Contact usIndex Hdmi34 EN Koninklijke Philips Electronics N.V. All rights reserved