If TV guide information comes from the Internet, the TV guide can also list analogue channels next to the digital channels. In the TV guide menu, you can view the current channel you are watching in a small screen. With the TV guide from the Internet, you cannot set reminders.
Set the TV guide information
If the TV is connected to the Internet, you can set the TV to receive the TV guide information from the broadcaster.
To set the TV guide information, press h, select S Setup and press OK.
Select TV settings > General settings > TV guide. Select From the broadcaster or From the Internet.
3.5
Switch to devices
Source list
In the list of connections - the Source menu - you can find the devices connected to the TV.
From this Source menu, you can switch to a device.
Source menu
To open the Source menu, press c SOURCE.
To switch to a connected device, select the device with the arrows w (left) or x (right) and press OK.
For some devices
To close the Source menu without switching to a device, press
cagain.
Automatic detection
When you connect a new device to the TV, the device is detected automatically and put in the Source menu. The device is shown as an icon (the device type) and has a name. If the device type does not correspond with the device, e.g. the TV says it is a player but it is not, you can change the type.
To change the type of the device, press * Device type and select a type that fits the device and press OK.
If the name does not fit the device or you want to give the device a name of your own, press * Rename. Use the remote control keypad to enter a new name.
An appropriate device type helps you in using the device. The device type determines picture and sound styles, resolution values, specific settings or the position within the Source menu.
When you connect a new device to the TV, the icon of the device jumps to the front of the Source menu.
If the TV does not detect the device automatically, select the connection where you connected the device and adjust the Device type and name.
Original name and icon
To restore the device icon to its original name and type icon, press o OPTIONS, select the Options tab in the menu bar and select Original name and icon and press OK.
Scan connections
To rescan all TV connections and update the Source menu, press o OPTIONS, select the Options tab in the menu bar, select Scan connections and press OK.
From standby
With the TV in standby, you can switch on a connected device with your TV remote control.
Play
To switch on both disc player and TV from standby and start playing the disc or programme immediately, press x (play) on the TV remote control.
The device should be connected with an HDMI cable and both TV and device must have HDMI CEC switched on.
Home Theatre System
You can switch on your Home Theatre System to listen to an audio disc or a radio channel and leave the TV in standby.
To only switch on the HTS, with the TV in standby, press c SOURCE on the TV remote control.
EasyLink
With EasyLink you can operate a connected device with the TV remote control. EasyLink uses HDMI CEC to communicate with the connected devices. Devices must support HDMI CEC and must be connected with an HDMI connection.
In Help, press * List and look up EasyLink for more information.
32 | TV / Subtitles and languages |