Switching on and set up the TV
Before you switch on the TV, check that the AC power cord is properly connected. Press . POWER at the right side of the TV, or press
.
After you read a welcome screen, follow the
Select your menu | ●● EnglishEnglish |
language with the | |
Up/Down buttons on | ● Français |
your remote control, | |
press the OK button to | ● Español |
proceed. | |
|
|
Press Î or ï to select the desired mode for energy saving, then press OK.
| Location Home is recommended | Retail store |
|
|
| ||
|
| ||
| for normal home use. In the |
| |
|
|
| |
| Retail Store location all settings | Home |
|
| are fixed. |
| |
|
|
|
|
|
|
|
|
|
|
|
|
Select [Retail store] if you want backlight to be brighter. Select [Home] to reduce the power consumption.
You must set [Home]. Otherwise, the settings of picture and sound quality you adjusted will not be memorized after you turn off the unit.
•Select [Retail store], the unit will be set up with predefined setting for retail displays. In this setting, the power consumption may possibly exceed the limited requirement of the ENERGY STAR® qualification.
•Select [Home], the unit is set to maximize the energy efficiency for home setting and it can be adjusted through a choice of picture and sound quality according to your preference.
Press Í or Æ to select [Start], then press OK to begin [Settings assistant].
Settings assistant will allow you to customize your picture settings to your personal preference. You will see a series of test pictures where the right side and left side differ. Select the side that is most pleasing to you with the Left/Right buttons.
Cancel Start
Select [Picture A] or [Picture B] by pressing Í or Æ that is the most pleasing to you, then press OK.You see 5 different pictures to be completed.
Which side of the picture do you prefer?
Cancel | Picture A | Picture B |
Press Í or Æ to select [Store], then press OK
Store your preferences.
Cancel Store
Press OK to finish [Settings assistant]
The TV has learned your preferences.
Exit
Press Í or Æ to select [Finish], then press OK.
Finish the Setup.
Note
•If you are not receiving a signal from your cable service, contact the CATV provider.
•If you press . during autoprogram, an installation will be canceled except the language selection.
•The initial autoprogram function can be executed for either [Antenna] or [Cable]
only once.When you change the connection (Antenna / Cable), set autoprogram again. (Refer to page 26.)
E n g l i s h
EN 11