AUTO PROGRAM (SETTING UP CHANNELS)
Your LCD TV can automatically set itself for local area (or cable TV) channels. This makes it easy for you to select only the TV stations in your area by
pressing the CH (+) or CH (-) button.
MAIN CONTROLS
1
2
3
4
5
6
Press the MENU button on the remote control to show the onscreen menu.
Press the CURSOR DOWN button to highlight the INSTALL menu.
Press the CURSOR RIGHT button to enter the INSTALL menu.
Press the CURSOR DOWN button to highlight the AUTO PROGRAM control.
Press the CURSOR RIGHT button to start the AUTO PROGRAM scanning of channels.
Press the MENU button repeatedly to clear the menu from the screen, after AUTO STORE has finished.
1
�
�
�
�
�
PICTURE | LANGUAGE |
AUDIO | TUNER MODE |
FEATURES | AUTO PROGRAM |
INSTALL | CHANNEL EDIT |
| MANUAL FINE TUNE |
| FACTORY RESET |
INSTALL |
|
LANGUAGE | ANTENNA |
TUNER MODE | CABLE |
AUTO PROGRAM | AUTO |
CHANNEL EDIT |
|
MANUAL FINE TUNE |
|
FACTORY RESET |
|
INSTALL |
|
LANGUAGE |
|
TUNER MODE |
|
AUTO PROGRAM | START? |
CHANNEL EDIT |
|
MANUAL FINE TUNE |
|
FACTORY RESET |
|
|
|
AUTO STORE
PLEASE WAIT
PROG . FOUND0
CHANNEL3
HELPFUL HINT
•Immediately after unpacking and plugging in your new television, run the auto program function to set up the TV for the broadcast or cable channels available in your area. If you do not run the auto program function to set up the channels , your television may not operate properly.
•After you’ve run Auto Program, check out the results. Press the CURSOR DOWN or the CURSOR UP button and see which channels you can select.
•Remember, an antenna or cable TV signal must first be connected to your LCD TV.
8