Philips 191TV4L Using TV signal as the input source, Channels list, Channels and antenna

Page 14

7TV/Channel installation

This chapter describes the channel installation settings.

Using TV signal as the input source

channels

 

picture

sound

setting

channels list

 

 

channels and antenna

 

select

MENU back

exit

 

 

1.Press MENU to display the menu.

2.Press ◄ or ► to select [channels].

3.Press OK to confirm your selection.

Channels list

You can edit a list of your preferred TV channels so that you can find those channels easily.

channels channels list

12-1

TV 1

 

 

12-5

Temp TV 5

 

 

 

12-2

Promo TV 2

 

 

12-6

Radio 6

 

 

 

12-3

TV 3

 

 

12-7

Temp Radio 7

 

 

 

12-4

TV 4

 

 

12-8

 

 

 

 

favorite

skip

block

 

delete

MENU back

exit

1/2

1.Press MENU.

2.Press ◄ or ► to select [channels] and press ▼ to select [channels list].

3.Press OK to confirm your selection. »» The channels list appears.

4.Follow the on screen instructions.

[Favorite]: Add the selected channel to the favorite channel list.

[Skip]: Skip the selected channel. The selected channel will be skipped when using the P +/- to switch the channels.

[Block]: The selected channel will be block. You can access the block channel by entering the password.

[Delete]: Delete the channel from the channel list.

Channels and antenna

Select TV source signal and search new channels.

channels channels and antenna

TV signal source

air

add channels

 

new channel scan

 

services navigation

off

enable one-seg

off

 

 

select

MENU back

 

exit

 

1.Press MENU.

2.Press ◄ or ► to select [channels] and press ▼ and ◄ or ► to select [channels and antenna].

3.Press OK to confirm your selection.

»» The channels and antenna submenu appears.

4.Select one of the following options and press OK.

[TV signal source]: Select TV source signal from air or cable.

[Add channels]: Scan all channels and store in the channel table automatically.

[New channel scan]: Add channels which are new found.

[Services navigation]: Shift through the channel services using keys P+/- for primary channels.

[Enable one-seg]: Enable the display of one-seg content.

12EN

Image 14
Contents Troubleshooting 191TV4LModel Contents Koninklijke Philips Electronics N.V. All rights reserved Safety Risk of electric shock or fireRecycling Unplug the monitor before cleaningScreen care Get started and connect your devices Back connectorSignal input from an antenna, cable or SatellitePC in VGA and Audio Audio and video input from a computer Side connectorFor service only Side control buttons Remote controlControls Select connected devicesPress to display a list of options Navigation buttons Access the services of the current DTV channelSwitch stereo mode Press to open or close the on-screen menuStart to use Switch your monitor on/off or to standbySwitch channels This section helps you perform basic monitor operationsWatch connected devices To select from the Source buttonProduct information Supported display resolutionsPower Tuner/Reception/TransmissionChannels and antenna Using TV signal as the input sourceChannels list Adjust Picture Setting SettingsAdjusting Preset Setting Press Menu Press or to select picture and pressAdjust Audio Setting Feature Setup System reset Restore all the default settings Pixel policy Pixels and Sub pixelsPixel Defect Tolerances TV channel issues TroubleshootingGeneral monitor issues Picture issuesComputer connection issues Sound issuesHdmi connection issues Contact usVersion M4191TVE1BZT