Watch connected devices

Philips 191TV4L user manual Watch connected devices, To select from the Source button

Page 12

Note

•• Switch on the connected device before selecting it as a source on the monitor.

To select from the SOURCE button

1.Press SOURCE to display the source list. »» The source list appears.

2.Press ▲, ▼, ◄, or ► to select a device.

3.Press OK to confirm your selection.

To turn up or down the volume

•Press VOL +/- on the remote control.

•Press VOL +/- buttons at the side of the monitor

To mute or restore the muted sound

•Press to mute the sound.

•Press again to restore the sound.

10EN

Image 12

Contents

Troubleshooting 191TV4LModel Contents Koninklijke Philips Electronics N.V. All rights reserved Safety Risk of electric shock or fireUnplug the monitor before cleaning Screen careRecycling Back connector Signal input from an antenna, cable orGet started and connect your devices SatelliteSide connector For service onlyPC in VGA and Audio Audio and video input from a computer Remote control ControlsSide control buttons Select connected devicesAccess the services of the current DTV channel Switch stereo modePress to display a list of options Navigation buttons Press to open or close the on-screen menuSwitch your monitor on/off or to standby Switch channelsStart to use This section helps you perform basic monitor operationsWatch connected devices To select from the Source buttonSupported display resolutions PowerProduct information Tuner/Reception/TransmissionUsing TV signal as the input source Channels listChannels and antenna Settings Adjusting Preset SettingAdjust Picture Setting Press Menu Press or to select picture and pressAdjust Audio Setting Feature Setup System reset Restore all the default settings Pixel policy Pixels and Sub pixelsPixel Defect Tolerances Troubleshooting General monitor issuesTV channel issues Picture issuesSound issues Hdmi connection issuesComputer connection issues Contact usVersion M4191TVE1BZT