Philips 15PF5120/28B setup guide Antenna TV, Basic Cable TV Connection

ANTENNA TV

A combination antenna receives normal broadcast channels (VHF 2–13 and UHF 14–69). Your connection is easy because there is only one 75 Ω (ohm) antenna jack on the side of your TV, and that’s where the antenna goes.

1If your antenna has a round cable (75 ohm) on the end, then you’re ready to connect it to the LCD TV. If your antenna has flat, twin-lead wire (300 ohm), you first need to attach the antenna wires to the screws on a 300- to 75-ohm adapter(not supplied).

2Connect the antenna (or adapter) to one end of the supplied L-Adapter as shown, and connect the other end of the L-Adapter to the TV jack on the side of the LCD TV.

TV

3Plug the DC adapter into the DC IN 16V jack on the LCD TV. Plug the power cable into an outlet and switch TV set on.

4Run the AUTO PROGRAM function to set up the TV for the broadcast or cable channels available in your area. If you do not run the auto program function to set up the channels , your television may not operate properly.

HELPFUL HINT

• Remember, an antenna or cable TV signal must first be connected to

your LCD TV.

3	DC IN
	16V

Outdoor or Indoor Antenna (Combination VHF/UHF)

DC Adapter

Twin-lead	Power
wire to	Cable
300-75Ω
adapter

DVI-I IN AUDIO IN

DVI (HDCP / PC ANALOG)

Television

1 2

OR

• Please make sure that you have selected the TV mode with AV+ key

on your remote control, before installing TV channels.

Antenna with 75 Ω cable

BASIC CABLE TV CONNECTION

Your Cable TV input into your home may be a single (75 ohm) cable or use a cable box decoder. In either case the connection is very simple. Follow the steps below to connect your cable signal to your new television.

Direct cable connections:

1Connect the Cable TV signal to one end of the supplied L-Adapter as shown, and connect the other end of the adapter to the TV jack on the LCD TV.

2Plug the DC adapter into the DC IN 16V jack on the LCD TV. Plug the power cable into an outlet and switch TV set on.

3Run the AUTO PROGRAM function to set up the TV for the broadcast or cable channels available in your area. If you do not run the auto program function to set up the channels , your television may not operate properly.

HELPFUL HINT

•Remember, an antenna or cable TV signal must first be connected to your LCD TV.

•Please make sure that you have selected the TV mode with AV+ key on your remote control, before installing TV channels.

The Cable TV signal from Cable Company

(75 Ω coaxial cable)

L Adapter

TV

1

DC IN	DVI-I IN	AUDIO IN
16V

2	DVI (HDCP / PC ANALOG)
Power Cable

4