DQS Power Wiring, DQS Audio Wiring

The Strength of Digital™

B. DQS Power Wiring

WARNING: Failure to disconnect the negative terminal of your battery prior to the installation of your DQS can result in a warm tingly feeling.

Remote Turn-On:Connect an 18 to 22 gauge wire from the head-unit’s remote turn-on to the “Remote” connector on the DQS .

Positive (+12V) Connection: Insert a 12 to 18 gauge wire into the connector labeled “Power” on the nifty connector of your DQS. Connect it to a good constant source of 12 volts (we suggest the battery), fused at 2 amps.

Ground Connection: Use the same gauge wire or larger as you did for the positive connector and run it from the “Ground” connector on the DQS to the negative terminal of the battery, a ground bus, or a verified ground location. The factory head unit ground is not, not, not a good ground! When the electrical connections are complete, you may now reconnect the negative terminal to your battery.

C. DQS Audio Wiring

Planning: As you may already have guessed, there are numerous ways to configure the DQS in your audio system. Spend a little quality time planning out your system and even sketching it out on paper. The following diagrams are just a few of the system options:

Owner’s Enjoyment Manual