Memories Recall Save, Mode Memories | AudioControl DQS instruction

The Strength of Digital™

ting. If you wish to select another frequency, tap the left or right arrow buttons until the cursor is flashing on the number next to “Freq=”. Then use the “+” and “-” controls to select the frequency to which you wish to apply boost or cut.

Lvl: When the cursor highlights this part of the screen, you can now apply boost or cut to both channels using the “+” and “-” controls. Please note that you do not have individual channel control using the parametric equalizers.

Width: This control lets you select how wide of an area each of the DQS’s parametric bands affects. You can choose a real narrow bandwidth, like 1/12 th of an octave or go as wide as three full octaves.

MODE : Memories

This screen allows you to save or recall settings to or from one of the eight memory locations. Using the Left and Right arrows will cause the cursor to highlight one of the following func- tions:

Recall: When the cursor is flashing next to this word, you have the ability to recall one of the eight memories. Push the “+” or “-” buttons to scroll through the memories and select a memory to recall.

Memories	Recall	#1
	Save	#1

Figure 11: Memory screen

Save: Once you have made your equalization settings, you will want to save them in one of the eight memory locations. When the cursor is flashing next to the word “Save”, use the “+” or “-” buttons to select a memory location. Once you have selected a memory location, tap either the “Left” or “Right” button and the cursor will move to the bottom left of the screen between “N(-)” and “Y(+)”. Tap the (+) button to complete the saving process or tap (-) to quit.

Please note that while you are RECALLING or SAVING a memory, the cursor will stop blinking. Once the processor has SAVED or RECALLED all your settings, it will begin flashing again.

Owner’s Enjoyment Manual