Philips 50PP8541, 43PP8541 manual Video Recorder Playback

Unplug the RF cable from the RF socket of your video recorder.

CONNECTING PERIPHERAL EQUIPMENT

1

2

3

Video Recorder : Playback

Connect the RF cable to the RF socket on your video recorder.

Connect another RF cable from the output of your video recorder to the ANTENNA IN 75Ω socket on your TV.

Better playback quality can be obtained if you also connect the Video, Audio Left and Right (only for stereo equipment) cables to the VIDEO and AUDIO L (mono) and R inputs of

INPUT-AV 2.

CABLE

ANTENNA IN 75Ω	REAR OF TV	1
	AV5-RGB, 480p/1080i-60Hz, 576p-50Hz
	AV4-480p/1080i-60Hz, 576p-50Hz
	G/Y

Note : In case of mono equipment, only the left loudspeaker				Y			B/Pb
							R/Pr
			INPUT-AV 1	MONITOR	INPUT-AV 2		SUBWOOFER
				OUT
reproduces sound. Use a mono-to-stereo adaptor (not supplied)	2	3	VIDEO		VIDEO		SYNC	L	L
			L		L	VIDEO
			S-VIDEO	Pb	S-	L	V
			L
for sound reproduction via the internal loudspeakers.			AUDIOR	Pr	AUDIOR		H	AUDIOR	AUDIOR
The MONITOR OUT connectors can be used for daisy chain-		A/V OUT
ing or recording programmes from your TV. See page 32.	RF OUT		RF IN
S-VHS-Video quality with an S-VHS video recorder is obtained
by connecting the S-VHS-Video cable with the S-VIDEOinput
instead of connecting the video recorder to the VIDEO input.		VIDEO RECORDER
See the handbook for the video recorder.

If You Do Not Make the Video and Audio

Connections in Step 3 Above :

Search for and store the test signal of the video recorder.

1

Switch on your TV and put the video recorder on the test signal or

2 play a prerecorded tape. See the handbook for your video recorder.

3

4

5

Search for the test signal of your video recorder in the same way you searched for and stored the TV signals. See pages 9 and 10.

Store the test signal under programme number 0 or between 90 and 99.

Replace the RF cable in the RF socket of your video recorder after you have stored the test signal.

30