1.CONNECTING YOUR TV-VIDEO COMBI
Important for the United Kingdom |
| Connecting the cables |
This apparatus is fitted with an approved moulded 13 Amp plug. To change a fuse in this type of plug proceed as follows:
aRemove fuse cover and fuse.
bFix new fuse which should be a BS1362 5A, A.S.T.A. or BSI approved type.
cRefit the fuse cover.
If the fitted plug is not suitable for your socket outlets, it should be cut off and an appropriate plug fitted in its place.
If the mains plug contains a fuse, this should have a value of 5A. If a plug without a fuse is used, the fuse at the distribution board should not be greater than 5A.
DNote: * The severed plug must be destroyed to avoid a possible shock hazard should it be inserted into a 13A socket elsewhere.
How to connect a plug:
The wires in the mains lead are coloured in accordance with the following code:
BLUE - ’NEUTRAL’ (’N’) BROWN - ’LIVE’ (’L’)
dThe BLUE wire must be connected to the terminal which is marked with the letter ’N’ or coloured BLACK.
eThe BROWN wire must be connected to the terminal which is marked with the letter ’L’ or coloured RED.
fDo not connect either wires to the earth terminal in the plug which is marked with the letter ’E’ or by the safety earth symbol \or coloured green or
Before replacing the plug cover, make certain that the cord grip is clamped over the sheath of the lead - not imply over the two wires.
aInsert the aerial plug into the 2 socket.
bInsert the plug of the mains cable into the wall socket.
cIf the little red light at the front panel of the set is not lit,
please switch on the set. The power switch 8 is located on the left side panel of the set.
Connecting a decoder or other equipment
You can also connect additional equipment to the EXT.1
socket. For instance, a satellite receiver, decoder or camcorder.
4