Philips SVZ122 Before Using Your VCR, Putting Batteries in the Remote Control, Erasure Prevention

Page 5

SVZ122(H1680).QX33 4/6/99 9:42 PM Page 5

Before Using Your VCR 5

Putting Batteries in the Remote Control

1

Remove the battery compartment lid on the bottom of the remote control by sliding the lid in the direction of the arrow.

2

Insert two AA batteries inside the battery compartment with their + and – ends aligned as indicated.

3

Replace the battery compartment lid.

Using the Remote Control

●Point the remote control at the VCR’s remote sensor (see page

21)when using the remote control to operate the VCR.

●Do not put objects between the remote control and the VCR.

1

2

3

Erasure Prevention

Video cassette tapes have record tabs to ensure that recordings are not erased accidentally.

1

To prevent accidental erasure, break off the tab with a screwdriv- er.

2

To record again, cover the hole with cellophane tape.

VCR maintenance

●In this VCR, use only tapes with the mark.

●Make sure any light adhesive stick-on notes are removed from the video cassette tape before putting the tape in the VCR. Removable labels like these can jam the VCR.

●Periodic maintenance is required to maintain your VCR’s per- formance. The video heads will eventually require cleaning or replacement. Cleaning or replacement of the video heads should be performed by an authorized service center.

1

2

Helpful Hints

•The remote control and its batteries are supplied.

•Do not mix alkaline and man- ganese batteries.

•Do not mix old and new batteries.

Image 5

Contents Video Cassette Recorder For Customer Use Warranty VerificationIntroduction FeaturesSafety Precautions Table of Contents Putting Batteries in the Remote Control Before Using Your VCRUsing the Remote Control VCR maintenanceDisconnect the antenna or cable from your TV Hookups Without a Cable Box / Direct Broadcast SystemANT Audio OUT Plug in the TV and the VCRRecording/Viewing Any Channel Hookups With a Cable Box / Direct Broadcast SystemConnections Recording One Channel/Watching Another Hookups With a Cable Box / Direct Broadcast System cont’dHookups With a Stereo TV 2Turn on the TV Turning on Your VCRAutomatic Channel Setup Adding/Deleting Channels Automatic Channel Setup cont’dFollow the steps below to set your VCR’s clock. Make sure Setting the ClockSetting the Clock cont’d Language Selection Press the Counter RESET/EXIT button to exitOn-Screen Status Displays OFF mode Press the Display button once Count modePress the Display button once Clock mode Power Button Remote Control ButtonsNumber Buttons Rental Selector ButtonEject Button Counter RESET/EXIT ButtonAuto Repeat Button CLOCK/COUNTER ButtonVCR Display Panel Front Panel Rear Panel AC Power CordAudio OUT Jack Video OUT JackRead and follow the steps below to play a tape Playing1Turn on the TV Insert a tape RecordingStopping an OTR One-Touch RecordingStarting an OTR Program Number → Once Daily Weekly Timer RecordingRepeat the procedure in to set the recording’s end time Timer Recording cont’dPress the Counter RESET/EXIT button Timer recording. Details are on page eightCorrecting a Timer Recording Cancelling a Timer RecordingSelect Auto Return Auto ReturnPress the Play button or the Stop button repeatedly to To return to the channel being recorded, use the TV Press the VCR/TV button on the VCR remote control toPut the VCR in VCR position. The VCR/TV light will appear To stop recording, press the Stop buttonAntenna Rerecording Tape DuplicationRepeat Play Forward and Reverse Searching SP/LP/SLP Special Effects PlaybackSuper High Speed Searching LP/SLP Viewing a Still PictureRental Play Press the Play button to watch the tape Real-Time Counter MemoryAutomatic Playback Features Helpful Hints Helpful Hints cont’d Cable Box/DBS Output Channel Channel 3 or GlossarySpecifications Video Cassette Recorder Limited WarrantyIndex Supplied Accessories