Philips VRZ241AT owner manual Do each step within 60 seconds of the previous step

VRZ241(H1795).QX33 4/9/99 9:17 AM Page 36

36 Timer Recording With the VCR Plus+ Programming System

Follow these steps to set a timer recording with the PlusCode programming numbers in your TV guide. Before you begin:

●Set up the channels at the VCR (page 12).

●Set up the VCR Plus+ and Cable/TV channel numbers (pages 34 - 35).

●Set the clock (page 15).

●Put a tape in the VCR.

●Turn on the VCR power. The VCR light should appear on the display panel. If it does not, press the VCR/TV button once.

Do each step within 60 seconds of the previous step.

1

POWER	VCR	TV	CBL/DBS
	2	3	VCR/TV
1
4	5	6
			CHANNEL

3

1

Press the VCR button.

2

2

4

7 8 9

VCR PLUS+
/ENTER
	0	+100
SPEED	TIME SEARCH	MUTE

PLAY

REW

STOP

VOLUME

F.FWD

Press the VCR PLUS+ /ENTER button.	REC/OTR	MEMORY	SLOW	PAUSE/STILL
VCR PLUS+ PROG.	MENU	STATUS/EXIT CLEAR		EJECT
PLUS CODE : – – – – – – – –

TO END PUSH EXIT

3

Press the Number buttons to enter the PlusCode pro- gramming number of the program you wish to record. Then, press the VCR PLUS+ /ENTER button.

VCR PLUS+ PROG.

PLUS CODE : 13285 – – –

TO SET PUSH VCR+

TO CORRECT PUSH CLEAR

TO END PUSH EXIT

4

Press the PLAY/o button or the STOP/p button to select a ONCE, DAILY, OR WEEKLY recording. Then, press the F.FWD/B button.

●ONCE: The VCR will record a TV program on any day you choose, up to 12 months away.

●DAILY: The VCR will record every day from Monday to Friday

– starting at the same time and recording for the same length of time.

●WEEKLY: The VCR will record on the same day, at the same time, and for the same length of time every week.

VCR PLUS+ PROG.

→ONCE DAILY WEEKLY

SELECT op CHOOSE B

TO END PUSH EXIT

Helpful Hints

•CODE ERROR may flash on-screen after step 3 if you enter an incorrect number (for example, one that is too short). The previous screen will appear. Enter the correct PlusCode programming number.

•If the VCR PLUS+ CROSS REF. MAP reappears after step 3, the VCR PLUS + channel number for the recording you entered was higher than 99. In this case, enter the cor- rect CABLE/TV channel in the map. Then, press the MENU button and continue from step 4.

•If CLASH flashes on-screen at step 3, the timer recording you just pro- grammed and another timer record- ing overlap. The current timer record- ing will not occur.