Programming using “VIDEO Plus+”
Using this method, programming becomes as easy as dialling a telephone number. Your need only enter the (three to
The PlusCode can be entered in the OSD page on screen or in the video recorder display.
Ensure that a cassette without erase protection is inserted.
!Switch on the TV set and select the channel num- ber for the video recorder.
"Press the remote control button o. The OSD page “TIMER” appears on screen.
¤Select the line “VideoPlus”. Confirm this by pressing the button _.
$The OSD page “VIDEOPLUS” appears on screen.
VIDEOPLUS
– – – – – – – – –
once
Ddaily
W weekly
//D/W - SELECT Confirm - OK
%Enter the whole PlusCode using numeric buttons k. If you make a mistake when keying in, dele- te by pressing the button m.
&If you wish to programme daily or weekly recordings, select the line “daily” or “weekly” by pressing the button p.
Daily recordings can only be programmed for the weekdays Monday to Friday.
/Press the button K. The programmed code is now decoded. Following correct decoding, the corresponding data appears on screen and in the video recorder display.
ENGLISH
Some important information:
*If the programme number flashes, e.g.: 'P01', you must confirm the programme number contained in the 'PlusCode' on the video recorder with the B button. With programme numbers starting from
P05 and above for the first time, the programme number “E 2” is used.
The message “Please enter programme number” appears in the screen display.
Select the “correct” programme number using the button for e.
Confirm this by pressing the Bbutton.
The video recorder now uses this programme num- ber for all future VIDEO Plus+ programmings for this TV channel.
*Using the button p, the “PDC” function can be switched off and back on again.
*If you wish "subtitles" to be recorded also, press the pbutton. Enter the number of the subtitles page as three digits with the numeric buttons O.
(Have you entered all the data correctly? If you have, press the Bbutton.
“Timer ready” appears briefly in the screen display. The symbol “Å” appears in the video recorder display. It indicates that a TIMER has been programmed.
)Terminate with the dbutton.
Some important information:
*If you wish to use the programme number “E2” in order to record from an external source (e.g. from a
satellite receiver), confirm the programme number “E2” indicated in Step / by pressing the button
B
*If “CODE ERR” appears in the display,
the numerical code is wrong or has been entered wrongly. Repeat the entry or terminate by pressing the button d.
*If “SET CLOCK” appears in the display, the internal clock of the video recorder has not been set. Set the clock.
*Daily recordings can only be programmed for the weekdays Monday to Friday.
*In case of “daily/weekly” programming, the first recording must be made within the first week.
*Some TV programmes go on for longer than
advertised. If you wish to enter a later end time, sel- ect “End” using the button _in Step / and enter the end time using the button for eor the numeric buttons k.
*The “VIDEO PLUS” menu appears straight after Step " if you have set the display “Video Plus” on the OSD page “PERSONAL PREFERENCES”.
(See Step % of the section “Setting the video recor- der to your individual operating requirements” in Chapter 8).
21