View mode
You can view the picture from an external unit connec- ted to the socket uof your video recorder on the picture screen (monitor) of a TV set. The external unit can be, for example, a second video recorder,
a decoder or a satellite receiver.
•If the external unit transmits a control signal, this is recognized by the video recorder and it switches automatically to the view mode.
You can switch the view mode on and off with the abutton.
Notes:
*If the programme position "E1" or "E2" is selected, the video recorder cannot switch in the view mode. This also applies for programme posi- tions with activated decoder function.
*This function is only possible if the TV set is equipped for it and a Scart cable is used for the connection.
The TV monitor function
Press the abutton to switch the TV set to the "AV" (= Audio/Video input) programme position. This is useful if you wish to monitor a "running" recording on the picture screen (monitor) of your TV set. For this, the video recorder must be switched on. The video recorder display indicates briefly
"VCR MON".
A further pressure on the same button switches the monitor function off. The video recorder display indi- cates briefly "TV MON".
Notes:
*The monitor function is only possible if the TV set is equipped for it and a Scart cable is used for the connection.
*During playback, the abutton has no function.
Switching between VCR 1 and VCR 2
This function is very useful if you have two video recorders operating with the same remote control code. So that you always control the "right" video recorder, you simply change the remote control code of this recoder and of this remote control handset.
!Switch on the TV set and select the programme position intended for the video recorder.
"Press the Sbutton on the video recorder.
The OSD page "INSTALLATION MENU" appears on the picture screen.
¤Select the option "Special settings". Confirm with the Gbutton.
$The OSD page "SPECIAL SETTINGS" appears on the picture screen.
%Select the option "VCR Address".
On the picture screen appears the message "To change – alter remote control code first".
&Press simultaneously the numeric button " and the Bbutton .
The code of the remote control is changed.
To undo the change, press the numeric button ! and the Bbutton.
/Point the remote control at the video recorder and press any button (e.g. r) button on the remote control. The "new" remote control code is sent to the video recorder. In the OSD page appears the indication "VCR2".
The code of the video recorder is also changed.
SPECIAL SETTINGS
Channel/Frequency | CHAN |
16 :9 | on |
VCR adress | VCR1 |
Y/C CVBS input/output
Beeperon
To change - alter remote control code first
Exit - MENU
(Complete the setting by pressing the button ltwice.
42