Philips VR220CAT owner manual Helpful Hints cont’d

Page 39

Helpful Hints (cont’d) 39

TV programs cannot be watched normally.

•Put the VCR in TV position, then change channels at the TV. (Press the VCR/TV button so that the VCR/TV light disappears from the display panel. Details are on page 22.)

•Check the connections between the VCR, TV, antenna/cable, and Cable Box/Direct Broadcast System (if applicable). Details are on pages six-10.

Tape cannot be inserted.

•Insert the tape, window side up, with the record tab facing you.

•Make sure a tape isn’t already in the VCR by pressing the STOP/EJECT button on the VCR.

•Gently push on the center of the tape when putting it in the VCR. Never force the tape into the VCR.

•If a timer recording is programmed and the VCR power is off, you can not insert a tape without a record tab.

Tape cannot be removed.

•Make sure the power plug is completely connected to a power outlet.

•You have set a timer recording. Turn the VCR power on, then eject the tape. Be sure to insert a tape and turn off the power for your timer recording.

•Unplug the VCR power cord for five minutes. Then, plug in the power cord again, then press the POWER button on the VCR. If the tape does not eject, press the STOP/EJECT button on the VCR three to five times. If the tape still does not eject, you may need to have an authorized servicer remove the tape.

VCR ejects the tape when the REC(ord)/OTR button is pressed or when the VCR power is turned off to set a timer recording.

•Make sure the tape has a record tab. Details are on page five.

Poor reception

•You may need to tune your TV again.

The motor (cylinder) rotates even when the VCR is in Stop mode.

•To enable the quick play mechanism, the cylinder will rotate for about five minutes. This is normal. The quick play mechanism allows the tape mechanism to switch from Stop mode to Play mode in one second.

Direct Broadcast System Hookups

•Watching one TV channel while recording another may not be possible if you have a DBS hookup. You may have to set your TV to channel 03 or 04, then make your channel selections at the DBS.

•If you use audio and video cables to connect your DBS, VCR, and TV, you may have to put your VCR in Line Input mode (channel 001 or 002).

Line Input mode

•If you accidentally enter Line Input mode (AV FRONT or AV REAR will appear on your TV screen briefly), press the CH(annel) o/p buttons or use the Number buttons to select another channel.

Cleaning the Video Heads

•Your VCR automatically cleans the video heads each time you insert a tape. However, the heads may become dirty. If so, use a commercially-available head cleaner or have an authorized servicer clean the video heads. Eventually, the heads may need to be replaced.

The playback picture is too dim, too bright, or fluctuates in brightness.

•Some programs may be broadcast with copyright protection technology in order to protect the rights of copyright owners. This technology is used on programs that are recorded on video tapes or Digital Video Discs (DVDs), as well as some programs broadcast by antenna/cable/satellite television channels. Programs broadcast with copyright protection technology may not record clearly. Likewise, if you play a tape that is a recording of a copyright protected program, the picture may not be clear. Tapes of copyright protected programs may have a picture that is dark or dim, or the brightness of the picture may fluctuate. Therefore, you should avoid recording or playing copies of copyright protected programs.

This VCR incorporates copyright protection technology that is protected by method claims of certain U.S. patents and other intellectual property rights owned by Macrovision Corporation and other rights owners. Use of this copyright protection technology must be authorized by Macrovision Corporation and is intended for home and other limited viewing uses only, unless otherwise authorized by Macrovision Corporation. Reverse engineering or disassembly is prohibited.

Page 38 Page 40
Image 39
Page 38 Page 40
Contents VR220CAT Model No Serial No Dear Philips product ownerFor Customer Use This bolt of lightning indi- cates uninsulated materialDeclaration of Conformity FeaturesSafety Precautions IntroductionTable of Contents Before Using Your VCR Disconnect the antenna or cable from your TV Hookups Without a Cable Box / Direct Broadcast SystemPlug in the TV and the VCR CH3 CH4Cable Box/DBS Cable Signal RF coaxialConnections Recording/Viewing Any ChannelRF coaxial Cable 3TV’s Antenna Jack Cable SignalRecording One Channel/Watching Another 2Cable Box/DBSHookups With a Stereo TV Turning on Your VCR 2Turn on the TVPress the Menu button. The display shown below will appear Press the VCR button, then press the Menu button Automatic Channel SetupAdding/Deleting Channels Automatic Channel Setup cont’dPress the STATUS/EXIT button once or twice to exit Reviewing Memorized ChannelsSetting the Clock Follow the steps below to set your VCR’s clock. Make sureYou make each entry within 60 seconds of the previous entry Press the VCR button, then press the Menu button Daylight-Savings TimeLanguage Selection Remote Control Buttons Remote Control Buttons cont’d If you select Status ON, then select Counter only OFF On-Screen Status DisplaysStatus Display example only If you select Status ON, then select Counter only onVCR Display Panel Front Panel Rear Panel Playing VHS Quasi Play Back SqpbRead and follow the steps below to play a tape Recording Insert a tape with its record tab intact in the VCR1Turn on the TV 2Insert a tape in the VCR VCR/TV light will disappear from the VCR’s display panel Recording One Channel/Watching AnotherOne-Touch Recording Set the clock. Details are on Timer RecordingTimer Recording cont’d Timer Recording cont’d Press the STATUS/EXIT button. Program WAS COMTape Speeds Checking or Cancelling Timer Recordings Rerecording Tape Duplication Press the F.FWD/B button so that on appears beside Repeat PlayPress the STATUS/EXIT button to see the status display Real-Time Counter MemoryForward and Reverse Searching SP/LP/SLP Super High Speed Searching LP/SLPViewing a Still Picture Automatic Operation Features Blue Background Helpful Hints Helpful Hints cont’d Video Cassette Recorder or Player Limited WarrantyAccount number Limited Warranty cont’dTo obtain a replacement product from Philips Payment Amount $29.95 + Sales Tax = TotalGlossary/Specifications SpecificationsGlossary Automatic PowerRemote control TimerSupplied Accessories

VR220CAT specifications

The Philips VR220CAT is an innovative and versatile vacuum cleaner that redefines cleanliness with remarkable features and advanced technologies. Designed for modern households, this model encapsulates what consumers look for in a reliable cleaning solution: efficiency, power, and ease of use.

One of the standout features of the VR220CAT is its powerful suction capability. Equipped with a high-performance motor, it effortlessly lifts dirt, dust, and debris from various surfaces, including carpets and hard floors. The innovative Cyclone technology ensures that the suction power remains consistently strong throughout the cleaning process, providing thorough results without loss of performance.

The vacuum also boasts a unique multi-tier filtration system. This system traps both large particles and microscopic allergens, making the environment safer for those with allergies or respiratory issues. The HEPA filter effectively captures up to 99.97% of particles as small as 0.3 microns, ensuring that only clean air is released back into your living space.

The design of the Philips VR220CAT prioritizes user comfort and convenience. It features an ergonomic handle and lightweight structure, allowing for easy maneuverability around the home. Whether navigating tight corners or reaching high places, the vacuum's flexibility simplifies the cleaning task, reducing strain on the user.

Another notable characteristic of the VR220CAT is its versatility. The vacuum comes with a range of accessories designed for various cleaning scenarios. From floor brushes for carpets to crevice tools for tight spaces, this model can adapt to different surfaces and challenges, making it an all-in-one solution for home cleaning needs.

Furthermore, the vacuum incorporates a smart sensor technology that guides the cleaning process. By automatically adjusting the suction power according to the type of surface, it ensures optimal performance while conserving energy. This intelligent feature not only enhances cleaning efficiency but also extends the lifespan of the appliance.

In summary, the Philips VR220CAT is a cutting-edge vacuum cleaner that combines powerful suction, advanced filtration, user-friendly design, and smart technology. Its impressive performance and versatile capabilities make it an ideal choice for anyone looking to maintain a pristine home environment. With this model, Philips continues to demonstrate its commitment to quality and innovation in household cleaning solutions.
Top Page Image Contents