Audiovox CNPKEN1 manual Installation, Step

2

Installation

Step 1:

Remove the head unit from your dashboard.

Important: Depending on how your head unit was installed you may have to remove part or all of your dash board before the head unit can be pulled out. You may also have to remove screws to complete this step.

Note: Before proceeding, make sure that the PIA Adapter has been pro- grammed. Refer to the PIA Installation Manual. Professional installation is recommended.

Step 2:

Connect the 34-pin cable connector to the Programmable Interface Adapter (PIA) mating connector as shown in Figure 1. Slide the rubber strain relief onto the PIA case. Attach the Car Dock USB connector into the USB receptacle on the PIA. Make sure the connectors are secure, and slide the top cover onto the bottom housing. (Refer to Figure 2.)

Mini-Tunerand	Antenna
Car Dock

Pass-Through

Connector

Yellowand
black wire are
optionalbased	Mating
on model.	Connector
	Connector
	ToHeadUnit
Yellow Wire, 12V Battery
GroundWire	Fuse

Left/Right

AudioCable

Note: Make sure all cables are securely connected.

Figure 1. PIA Cable Interface