Audiovox CNPKEN1 manual Typical Head Unit, Rear View Step

Page 3

3

Installation (Continued)

Step 3:

Connect the end of the cable with the right angle DIN connector and audio cables to the back of the head unit as shown in Figure 2. The shorter end of the cable coming from the PIA is a pass-through cable that can be used to connect other products to your head unit, i.e., CD changer.

Left/Right Audio

Connector

 

Cables(ModelSpecific)

 

Figure 2. Typical Head Unit, Rear View

Note: The location of the connections on the head unit may vary depending on the model.

Step 4:

Start your car and turn on your head unit to confirm that the XM Direct system is properly connected. Please refer to your stereo owners manual on how to access XM mode. When you tune to XM channel 1, you should see “XM Preview” on your head unit LCD, and hear that channel through your car speakers. If not, check to make sure all connections are correct or refer to the troubleshooting section of this installation guide.

Step 5:

Mount and secure the interface cable in a suitable location that will not interfere with the radio and will not vibrate or rattle after installation.

Image 3
Contents Interface Cable Step InstallationTypical Head Unit, Rear View Step Smart Digital Adapter Completing Activation Antenna TroubleshootingMonth Limited Warranty 128-7984A