Chapter 5: EDID Configuration (Local Unit Only)
5. EDID Configuration (Local Unit Only)
In some cases, display problems may occur because of incorrect EDID communication between the display monitor and the unit or inappropriate EDID data programmed by display manufacturers. Press the “EDID Config” button on the top panel of the local unit to enable the unit to configure EDID from
Table
EDID Mode | Video EDID | Audio EDID | |
|
|
| |
| Auto mixing: Min. (of all) | Config local monitor | |
| (audio) EDID and all | ||
Auto mixing and | Automatically optimize all | ||
connected monitors use | |||
EDID Config | valid (video) outputs for | ||
the configured (audio) | |||
| minimum requirement | ||
| EDID | ||
|
| ||
|
|
| |
| Config local monitor | Config local monitor | |
| (video) EDID and all | (audio) EDID and all | |
EDID Config | connected monitors use | connected monitors use | |
| the configured (video) | the configured (audio) | |
| EDID | EDID | |
|
|
| |
| Auto mixing: Min. (of all) | Auto mixing: Min. (of all) | |
Auto mixing | Automatically optimize all | Automatically optimize all | |
valid (video) outputs for | valid (audio) outputs for | ||
| |||
| minimum requirement | minimum requirement |
NOTE: The default mode is auto mixing.
Page 14 |