8x8 and 16x16 VGA / HDTV Matrix Switch with Audio, RS232 & IP Control
3.2.12.2 IP Configuration through port 23
If you were unable to enter the IP setting mode through the serial command, a Telnet TCP programming method can be used to turn on
To open a Telnet section, a command prompt (Run: CMD) or a HyperTerminal window can be used:
For example, to run a HyperTerminal window, set it up for TCP/IP connection on PORT 23 along with the Matrix’s default IP address as the host address.
Telnet commands and replies have the following format:
STX
Command/reply
CR
•STX character (ASCII code 2 or
1.To use the IP configuration Telnet commands, you must first log in using the
(L) command.
Command:
2.To enable a serial IP setting (serial programming) mode, type the following commands:
Command:
Command:
Command:
Reboot the system by cycling power. Now you should be able to configure IP parameters through the IP port.
Alternatively instead of rebooting the system you could use
3.To get the current IP address:
Command:
Response:
4.To set a new IP address:
Command:
5.To get the current gateway IP address:
Command:
Response:
6.To set a new gateway IP address:
Command:
25 |