SVAT Electronics GX5150 Monitor Functions, Refer to under the multi-camera section of this manual

MONITOR FUNCTIONS

		Power
Menu		Scan
	Auto	Manual

1.POWER BUTTON: this button allows you to turn the monitor on/off by simply pressing the POWER button. The built-in LED of the power button may flash from time to time indicating a low battery when batteries are used.

2.MANUAL BUTTON: this button allows you to select a specific camera to be shown on the monitor. The monitor will switch to a different camera each time the Manual button is pressed. To avoid viewing channels that do not have cameras assigned, set the DIP switches (located on the rear panel of the monitor) on the unused channels up to the OFF position.

(refer to step 2 under the multi-camera section of this manual)

3.AUTO BUTTON: this button allows your system to automatically scan through all active cameras. When sound is detected on the pre-set sound trigger level on the camera, the monitor will display the picture from the camera for a few seconds and the beeper alarm will sound.

The dwell time (time taken to switch between cameras) is pre-set to 4 second intervals and can be adjusted between 2-30 second intervals. To adjust the dwell time, press both the auto & manual buttons simultaneously. Each flash of the LED increases the dwell time by one second.

4.SCAN BUTTON: pressing this button places the system in scan mode. The monitor screen turns blank and the system continuously scans active cameras for sound. If sound is detecteted through the camera that is above the pre-set trigger level, the monitor will display the active camera picture and the beeper will sound. Two minutes after the last detection, the screen returns to standby/scan mode and the monitor resumes scanning.

*NOTE: Pressing the Manual or Auto button will cancel this mode*

5.VOLUME: the audio volume of the palm monitor can be adjusted by tuning the volume tuner on the right side of the monitor.

6.ALARM VOLUME: the alarm volume of the monitor can be adjusted by tuning the alarm volume tuner on the left side of the monitor.

7.MENU BUTTON: Pressing the menu button on the left side of the monitor:

•LED ON, adjust BRIGHTNESS +/-

•LED Flashing, adjust COLOUR +/-

•LED Off, adjust CONTRAST +/-

w w w . s v a t . c o m