Assembly
IMPORTANT! Before assembly, inspect this product for damaged hardware, loose joints, missing parts or sharp edges. DO NOT use if any parts are missing, damaged or broken. Contact Mattel for replacement parts and instructions if needed. Never substitute parts.
Footrest
Seat Bottom
Seat |
| |
Bottom | Plastic | |
Tubes | ||
Rings | ||
|
Plastic
3
Rings
1
•Place the seat bottom face down on a flat surface.
•At an angle, fit the footrest on the seat bottom, as shown.
Seat Bottom Tubes | Plastic |
Rings |
Plastic
Rings
2
•Slide a seat bottom tube through each set of plastic rings on the seat bottom.
• Align the holes in the plastic
rings and the seat bottom tubes. | #8 x 1.9 cm (3/4") Screw- 4 | |
SHOWN ACTUAL SIZE | ||
• Insert a #8 x 1.9 cm (3/4") screw | ||
into each plastic ring and tighten. |
|
•Push the seat bottom tubes back and forth to be sure they are secured to the seat bottom. If the seat bottom tubes move, you have probably not fastened them properly. Remove the screws and check to be sure the screw holes in the seat bottom tubes and seat bottom plastic rings are aligned. Replace and tighten the screws.
Footrest
Insert Screws
Here
4
| #10 x 2.2 cm (7/8") |
• Insert two #10 x 2.2 cm (7/8") | Black Screw - 2 |
black screws through the foot- | SHOWN ACTUAL SIZE |
rest and into the seat bottom. |
|
• Tighten the screws. |
|
4