Assembly
Back Base
Tapered Leg Tube
8 |
|
Front Base |
•Identify the back and front base. The front base has tapered leg tubes. You will use the back base for the next assembly step.
Frame Decorated Side
#10 x 2.2 cm Black Screw - 2
Frame Back Legs
Screw Retainer - 2
Back Base Hole
Screw Retainers
Seat Height Adjusters
Position 4
Press Lever
10
•While pressing the levers on the seat height adjusters, lift them to position 4 on the frame front legs, as shown.
Seat Assembly
Sockets
11 | Seat Bottom Tubes |
|
9
Back Base Hole
• | Fit the seat assembly between the two frames. |
• | Insert the seat bottom tubes into the sockets in each seat |
•Position a frame so that the decorated side is outward.
•Insert the back leg of a frame into the back base.
•Fit a screw retainer over the hole in the back base, as shown.
•Insert a #10 x 2.2 cm black screw through the screw retainer and back base. Insert the back leg of a frame into the back base. Tighten the screw.
•Repeat this procedure to attach the other frame back leg to the other side of the back base.
Hint: The #10 x 2.2 cm black screws may have been assembled to the screw retainers.
height adjuster. |
Hints:
•Be sure the seat height adjusters are in the same position (position 4).
•You may need to push the frames apart slightly to fit the seat bottom tubes into the seat height adjuster sockets.
6