QPROBLEMS AND SOLUTIONS GUIDE
IMPORTANT! If you experience a problem with your vehicle, first check the Problems and Solutions Guide below. If you still experience a problem, please contact Power Wheels® Consumer Relations,
PROBLEM | POSSIBLE CAUSE |
| SOLUTION |
Vehicle does not run | Undercharged battery |
| Charge the battery. A new battery should have been |
|
|
| charged for at least 18 hours before using the vehicle for |
|
|
| the first time. After |
|
|
| at least 14 hours after each use. Never charge the battery |
|
|
| longer than 30 hours. |
|
|
| Check all connectors. Make sure the charger is |
|
|
| tightly plugged into the battery, and that the |
|
|
| charger is plugged into the wall. |
|
|
| Make sure power flow to the wall outlet is “ON”. |
| Charger is not working |
| There is no sure way to tell if your charger is working unless |
|
|
| you have a volt meter. If you suspect there is a problem with |
|
|
| your charger, contact your local Power Wheels® authorized |
|
|
| service center. They can test your charger for you. |
| Tripped thermal fuse |
| The |
|
|
| of the vehicle if the vehicle is overloaded or the driving |
|
|
| conditions too severe. Once a fuse has "tripped", remove |
|
|
| your foot from the pedal and wait approximately 25 seconds |
|
|
| before operating the vehicle again. To avoid repeated |
|
|
| automatic shutdowns, do not overload the vehicle by |
|
|
| exceeding the 130 lbs maximum weight capacity or by towing |
|
|
| anything behind the vehicle. Do not drive up hills or run into |
|
|
| fixed objects, which can cause the wheels to stop spinning |
|
|
| while power is still being supplied to the motors. If a thermal |
|
|
| fuse continually trips, contact your local Power Wheels® |
|
|
| authorized service center. |
| Loose wires or loose connectors |
| Check all wires and connectors. Make sure the motor |
|
|
| harness connector is tightly plugged into the battery and that |
|
|
| there are no loose wires around the motors. |
| Dead battery |
| If your battery is old or if you have not followed Battery |
|
|
| Care instructions, your battery may be dead. If you are |
|
|
| unsure whether or not the battery are dead, you can have |
|
|
| it tested at your local Power Wheels® authorized |
|
|
| service center. |
| Electrical switch damage |
| The electrical switches can become corroded due to |
|
|
| exposure to water or moisture, or can jam due to loose dirt, |
|
|
| sand or gravel. Contact your local Power Wheels® authorized |
|
|
| service center for diagnosis and repair. |
| Motor damage |
| Contact your local Power Wheels® authorized service center |
|
|
| for diagnosis and repair. |
|
|
|
|
30 | |
|
|