Assembly |
|
IMPORTANT! Be sure to adjust the seat in the most
Flared End forward position for
Handle Trike
Cover
15
Base/Handle
•Position the base/handle covers so that the flared end faces the front of the trike.
•Fit the base/handle covers onto the trike rear frame near the rear wheels.
•Insert two #10 x ¾" screws into each base/handle cover and tighten.
Assembly is now complete.
Label Application
Handle
Center of Label
Place Center
of Label Here
• Before applying the label, wipe the surface of the |
handle with a clean, dry cloth to remove any dust or oils. |
Front Wheel
Base/Handle Pin
• Remove the backing from the label. |
• First, position the center of the label on the handle, |
as shown. Then, smooth each end of the label outward |
to attach it to the handle. |
• For best results, avoid repositioning a label once it has |
been applied to the handle. |
Wheel Retainer | Wheel Retainer |
•Insert the base/handle pin through one wheel retainer,
a hole in the front wheel and into the other wheel retainer.
•Push the handle pin to “snap” it into place. Pull on the handle pin to be sure it is secure.
9