Assembly
12
Fork Arms
Pedal Axle Cover
| Groove |
Pedal Axle | #8 x 3/4" Screw – 4 |
| SHOWN ACTUAL SIZE |
•Place the front wheel assembly between the fork arms so that the pedal axle fits into the groove at the bottom of each fork arm.
•Place a pedal axle cover over the pedal axle on one fork arm.
•Insert two #8 x 3/4" screws into the pedal axle cover and tighten with a Phillips screwdriver. Do not
•Repeat this procedure to attach the other pedal axle cover to the other fork arm.
13
Handlebar
Frame Neck
Fork Post
Pedal Axle Cover
14
Gas Cap
• Insert and snap the gas cap into the hole in the frame.
15 Seat Retainer
Seat
Peg
Holes
•Position the seat upside down.
•Fit the small pegs on the seat retainer into the holes in the seat.
One-time assembly is now complete.
#8 x 3" Screw – 1 |
SHOWN ACTUAL SIZE |
•Turn the frame upright.
•Insert the fork post up through the hole in the neck of the frame. Make sure the fork is positioned so that the pedal axle covers face the rear wheels.
•Place the handlebar over the fork post and push it down onto the frame. Make sure the handlebar is positioned so that the screw hole faces the rear wheels and aligns with the screw hole in the fork post.
Helpful Hint: You may need to rotate the handlebar to align the holes.
• Insert the #8 x 3" screw into the hole and tighten with a | 6 |
Phillips screwdriver. Do not |