Assembly
Hole
Tubes
Motorized
Frame
Battery
Compartment
5 | Hole |
•Position the motorized frame so that the battery compartment is toward you.
•Position the tubes in the motorized frame so that they are toward the outer edges. The holes in the tubes should be visible through the notches in the motorized frame.
Feet | Feet |
L | R |
7
L
R
Motorized Frame
•Stand the assembly upright. All four feet should be flat upon the floor. Also, when standing behind the product, check for an L marking on the left foot and an R marking on the right foot.
•If the feet are not flat upon the floor, or the left and right feet have been reversed, simply remove both legs and replace them on the opposite tube in the motorized frame. Again, check to be sure all four feet are flat upon the floor.
Seat
6 | Button | Hole |
Elbow Foot | Red Dot Tube | |
|
|
•Locate the R and L on the underside of each elbow foot. The R indicates the right leg. The L indicates the left leg.
•While pressing the upper button on the right leg, fit it into the tube in the motorized frame. Make sure the upper button on the right leg “snaps” into the hole in the tube.
•While pressing the button on the left leg, fit it into the tube in the motorized frame. Make sure the button on the left leg “snaps” into the hole in the tube.
•When the legs are assembled correctly to the tubes in the motorized frame, you should not see the red dots.
Waist
Belts
Pad
Elastic
Loops
8
•Position the seat upright.
•Place the pad onto the seat with the ruffle toward the top of the seat.
Crotch Belt
•Fold the top of the pad down. Insert the waist belts through the slots in the pad. Make sure the waist belts are not twisted.
•Insert the two elastic loops on the pad through the holes in the seat bottom.
•Fold the bottom of the pad up. Insert the crotch belt through
4 | the slot in the pad. Make sure the crotch belt is not twisted. |
|