Fiesta Products 7305 manual TQ Radio System Setup, RANGE-TESTING the TQ Radio System

TQ RADIO SYSTEM RULES	Channel 1
Each time you prepare to run your model, you
	Brown
must clear your frequency to be sure no one	Channel 2
else in the area is using the same channel as	Red
	Channel 3
you. There are six possible channels, numbered
1 through 6. Each is represented by a color.	Orange
	Channel 4
Look at the crystal plugged into the back of
	Yellow
your transmitter to determine which channel	Channel 5
your model is assigned to.	Green
	Channel 6
Always turn your TQ transmitter on first and off	Blue

last. This procedure will help to prevent your

model from receiving stray signals from another transmitter, or other source, and running out of control.

Always have the transmitter turned on before plugging in the battery.

Always use new or freshly charged batteries for the radio system. Weak batteries will limit the range of the radio signal between the receiver and the transmitter. Loss of the radio signal can cause you to lose control of your model.

123

Always turn your	Plug in the battery.	Turn on the model.
transmitter on first.		see TQ Radio System Setup, step 4.

TQ RADIO SYSTEM SETUP

The TQ Radio System was pre-adjusted at the factory. The adjustment should be checked, before running the model, in case of movement during shipping. Here’s how:

1.Fully extend the chrome antenna mast on the transmitter and turn the switch on. The red indicator light on the transmitter should be solid red (not flashing).

2.Elevate the model so that all four tires are off the ground.

If you are holding the model, make sure hands and clothing are clear of the wheels and other moving parts on the model.

3.Plug the battery pack in the model into the speed control.

THE TRAXXAS TQ RADIO SYSTEM

4.The on/off switch is integrated into the speed control. With the transmitter on, press the ESC set button for ½ second, until the LED shines GREEN, then immediately release the button. This turns the model on (see page 14 for more on ESC setup and operation). To turn the ESC off, press the set button until the green LED turns off. Always disconnect your battery when the model is not in use.

5.Turn the steering wheel on the transmitter back and forth and check for rapid operation of the steering servos. Also, check that the steering mechanism is not loose or binding. If the steering operates slowly, check for weak batteries.

6.When looking down at model, the front wheels should be pointing straight ahead. If the wheels are turned slightly to the left or right, slowly adjust the steering trim control on the transmitter until they are pointing straight ahead.

7.Gently apply the throttle trigger to ensure that you have full forward and reverse operation, and that the motor stops when the throttle trigger is at neutral.

8.Once adjustments are made, turn off your model, followed by the hand held transmitter.

RANGE-TESTING THE TQ RADIO SYSTEM

Before each running session with your model, you should range- test your radio system to ensure that it operates properly.

1.Turn on the radio system and check its operation as described in the previous section.

2.Have a friend hold the model securely. Make sure hands and clothing are clear of the wheels and other moving parts on the model.

3.Make sure your transmitter antenna is fully extended, and then walk away from the model with the transmitter until you reach the farthest distance you plan to operate the model.

4.Operate the controls on the transmitter once again to be sure that the model responds correctly.

5.Do not attempt to operate the model if there is any problem with the radio system or any external interference with your radio signal at your location.

Remember, always turn the TQ transmitter on first and off last to avoid damage to your model.

Your speed control was adjusted to the radio from the factory. It is possible for the throttle trim control on the transmitter to have moved during transit

or while handling the transmitter. If the motor runs when the model is switched on, then move the throttle trim control on the transmitter until the motor stops. If anything more than a slight adjustment of the throttle trim control is required, then you should readjust your speed control. Refer to the adjustments section on page 14.

When rechargeable batteries begin to lose their charge, they will fade much faster than alkaline dry cells. Stop immediately at the first sign of weak batteries. Never turn the transmitter off when the battery pack is plugged

in. The model could run out of control.

6,7,8

TRAXXAS • 13