Uniden UBR243 manual Monitor Installation, Camera Installation, Placement Considerations

If any items are missing or damaged, contact our Customer Care Line immediately. Never use damaged products!

MONITOR INSTALLATION

1.Place the monitor in a location with clear reception from your camera(s).

2.If you are using the monitor as a stand-alone unit, flip out the stand on the back of the monitor and extend the antenna. Connect an AC adapter to the power input on the side of the receiver. If you are using the monitor in the cradle, insert it into the cradle and connect an AC adapter to the input jack on the back of the cradle.

3.Plug the power plug into a 120 volt AC (standard indoor) power outlet or surge protector.

4.Press and hold the power button to turn the unit on or off. Let the monitor charge for 6 hours prior to first time use so the built-in rechargeable monitor battery is fully charged. DO NOT remove the power cable from the monitor/cradle during the initial charge process. After the initial charge, recharge the monitor as needed.

5.Out of range displays until you turn on the camera.

CAMERA INSTALLATION

The UBR243 camera and mounting clip are a complete unit. The UBR243 camera does come with a separate suction cup bar. With it installed, you can mount the camera on glass or smooth metallic surfaces.

Placement Considerations

••

••

The camera included with your monitor is NOT weatherproof; it is an indoor camera.

The clearest line-of-sight between the camera and monitor is best. Walls, especially brick and concrete, can affect reception quality.

••

••

Avoid having a direct light source in view of the camera (ceiling or floor lamps).

Carefully plan where and how the camera will be positioned, and where you will route the cable that connects the camera to the power adapter.

9