Assembly
Back Base
PRESS
PRESS
3 | Handle Tubes |
•While pressing the buttons on the ends of the back base, insert it into the tubes in the handle. Make sure the back base “snaps” into place.
•Pull the back base to be sure it is secure to the handle tubes.
Front Base 
4 | Soothing Unit Groove |
|
•Turn the assembly upright.
•Position the soothing unit upright and fit the groove to the front base, as shown.
•Insert two 4 mm x 30 mm screws through the front base and into the soothing unit.Tighten the screws.