8BASIC OPERATION
Once you have set up your Baby Monitor, you will be able to hear the sounds in your baby's room through the Parent Unit. And also see the green and red sensor lights around the top of the Parent Unit rise and fall with the sound levels.
Note:
If the connection between the Parent and Baby Units is broken at any time the green Link light on the Parent Unit will flash slowly, the parent unit will beep to alter you that the link has been lost and the green and red sensor lights will cease to react to any sounds. Move closer to the baby unit or follow the directions in "Troubleshooting" chapter to
Power On/Off
Once connected to the power supply,
•Press [ 
] on each Unit to turn on the power.
•To switch off, press and hold the [ 
].
Monitoring
•Position the baby unit accordingly. It should be placed 1 metre to 1.5 metres away from the baby's cot on a flat surface.
•Take the parent unit to monitor.
•Audio picked up by the baby unit microphone is depicted on the 8 lights on the parent unit (5 green
and 3 red). The more audio is picked up, the more lights will be lit. When no audio is picked up, all 8 lights will be off.
•If the volume of the Parent Unit is turned off, an alert will sound when the audio reaches the second red led.
Note:
Do not position the baby unit and the parent unit close to each other as feedback may be generated.
Adjusting Volume
You can adjust the volume at which you hear your baby.
There are 5 volume levels and an Off setting on the Parent Unit.
Press [ 
] to increase the volume and [ 
] to decrease the volume. When adjusting the volume, the 5 green sound sensor lights will illuminate to indicate the volume level.
Paging
If the Parent Unit is misplaced, you can use [ 
] button on the Baby Unit to locate the Parent Unit.
•Press and hold [ 
] on the Baby Unit. The Parent Unit will automatically reset to mid volume and the paging alert will sound.