Getting started, Baby unit battery installation

2. Getting started

2.1Baby unit battery installation

The camera uses either 3 AA size batteries (non-rechargeable batteries recommended) or the household power mains. The Baby unit has no

charging function!

screw

IMPORTANT

The non-rechargeable batteries for the Baby unit are not supplied with your product. We recommend the batteries to be installed before use, so that the unit continues to work in the event of a mains power failure.

1.Loosen the screw in a counterclockwise direction using a small screwdriver. Remove the battery cover.

2.Install the 3 AA non-rechargeable batteries following the polarity as shown in the compartment. Close the battery compartment and tighten the screw in a clockwise direction.

3.Slide the power switch to the ON position. The power LED will light up in green.

To switch off the baby unit, slide the power switch to the OFF position.

NOTE

When the battery level is low, the power LED will turn orange and will flash.

WARNING

Do not mix old batteries with new ones. Keep batteries away from small children.

Do not short-circuit batteries or dispose of in fire.

Remove the batteries if this device is not going to be used for a long period of time.

ENGLISH

Getting started	7