1.Loosen the screw in a counterclockwise direction using a small screwdriver. Remove the battery cover.
2.Insert the wire tab of the rechargeable battery pack into the contact slot as shown above and fit the battery pack into the compartment.
3.Close the battery compartment and tighten the screw in a clockwise direction.
4.Press and hold pto switch ON the parent unit. - It will take a few seconds to start up the unit.
5.Press and hold pto switch OFF the parent unit.
NOTE
When the battery level is low, the power LED will turn orange and will flash. Charge the battery pack for at least 15 hours before using on battery power only.
NOTE
When the unit is powered up with either the power adapter or using the rechargeable battery pack, the LED will light up in green. If both the power adapter and rechargeable battery pack are used, the LED will light up in red.
2.4Parent unit power supply
1.Connect the small plug of the power adapter to the parent unit and the other end to the mains socket (230V/50Hz).
NOTE
Only use the enclosed power adapter (6V DC / 800mA).
ENGLISH
Getting started | 9 |
|
|