APC NBWL0456, NBWL0455 configurationmanual Lost password recovery, Basic View

Lost password recovery

To recover from a lost password:

1.Locate the reset switch on the bottom of the appliance.

2.Use a thin wire such as a paper clip to press the reset switch for 10 seconds. This causes the system to restart.

3.Once the system restarts, login within two minutes using the default login values:

–For Advanced View:

•User ID: apc

•Password: apc

–For the console:

•User ID: root

•Password: apc

Note: If you do not log in within two minutes after holding down the reset switch, you must repeat the procedure.

4.After you log in, change the password to increase security.

Basic View

Use the Basic View to view the current sensor data, image capture, and other appliance data in a HTML-based interface. Use the Basic View to perform basic appliance configuration. The configuration tasks available from the Basic View are limited and are included for initial appliance installation and setup. This view is provided to allow you to use a Web browser to view appliance status.

APC supports the following Web browsers:

•Microsoft Internet Explorer® 5.5 and higher (on Windows operating systems only)

•Mozilla®-based browsers that support Firefox® 1.x (on all operating systems)

•Netscape® 7.x and higher (on all operating systems)

Note: Other commonly available browsers also may work but have not been fully tested by APC.

NetBotz 455 Installation and Quick Configuration Manual 21