Assembly
CAUTION
This package contains small parts in its unassembled state. Adult assembly is required.
IMPORTANT! Before assembly and each use, inspect this product for damaged hardware, loose joints, torn fabrics, missing parts or sharp edges. DO NOT use if any parts are missing or broken. Contact
Leg | Leg with Wheel |
Peg
Peg
2
Leg with Wheel | Base |
|
| • Carefully turn the base assembly over. | |
|
| |
|
| • Match the number label on a leg with the number label on a |
|
| corner of the base. Fit the leg to the peg on the base. |
|
| • Insert two M6 x 40 mm screws into the leg and tighten with the |
| Peg | Allen wrench. |
| • Repeat this procedure to assemble the remaining leg with a | |
|
| |
Peg |
| wheel to the other corner of the base. |
|
| |
| Leg |
|
1
Hint: There are numbered labels on each leg and in each corner of the base. You will match the number on each leg to the number in each corner on the base.
•Carefully place the base on it's side.
•Match the number label on a leg with the number label on a corner of the base. Fit the leg to the peg on the base.
•Insert two M6 x 40 mm screws into the leg and tighten with the Allen wrench.
•Repeat this procedure to assemble a leg with a wheel to the other corner of the base.
Brace
3
•Turn the assembly upright.
•Position a brace so that it curves away from you.
•Fit the brace to the bottom of two legs, as shown.
•First line up the holes in the brace with the holes in the legs. Then, insert two M6 x 40 mm screws into each leg. Tighten the screws with the Allen wrench.
•Repeat this procedure to attach the other brace to the base assembly.