Assembly
Seat Back Tube 
Square Openings
5
•Position the seat back tube so that the square openings are upright.
•Fit the seat back tube onto the ends of the base wire.
•Push the seat back tube to be sure it is completely on the base wires.
6
•Insert a #8 x 1,9 cm (3/4") screw into the inside hole of each handle and tighten.
•Pull up on the seat back tube to be sure it is secured to the left and right base wires.
Seat Back Pocket
Bottom Pocket 
7
•Fit the pad seat back pocket over the seat back tube.
•Pull and fit the pad seat bottom pocket around the soothing unit and footrest.
Handles
8
•Fit the handles through the side openings in the pad.
5