Razor 300001-SL owner manual Removing Rear Axle, Replacing the Chain

Assembly and Set-Up

Turn power switch off before conducting any maintenance procedures. Before you begin, carefully turn unit upside down for easier access.

qRemoving Rear Axle

1 Using a 17mm open wrench loosen locknut and remove rear wheel located closest to the chain.

4 Remove both c-clips on the rear axle between the two bearings.

2 Use a 3mm Allen wrench to loosen the brake.

5 Lightly tap the end of the axle with a rubber mallet. DO NOT USE A HAMMER as this will damage the thread. The brake drum and sprocket must be slid along the axle as your tapping progresses.

3 Use a 3mm Allen wrench to loos- en the set screw on the sprocket.

6 When the axle end is clear of the bearing hanger, remove the axle.

qReplacing the Chain

Note: Chain should be periodically checked for grime build-up. If necessary remove any dirt and/or debris in and around the chain and re-lubricate with WD-40.

Master Link

Drive Direction

1 Locate the master link on the replacement chain and with a flat head screwdriver carefully disengage the clip from the chain to remove the link plate and connector link.

4 If needed, fine-tune the tension of the chain by using a 19mm open wrench to adjust the screw on the motor mounting. Be careful not to over tighten.

2 Wrap the chain around both	3 Using a flat head screwdriver,
sprockets and tension idler. Insert	carefully re-attach the clip on to the
the connector link all the way	link plate. The clip must point in the
through the chain and fit the link	drive direction of chain rotation.
plate over the connector link.

6

Master Link:

clip

link plate

connector link