Razor 20036560 ASSEMBLy and SET-UP, Attaching the front fork, Attaching the front Wheel

Page 4

ASSEMBLy AND SET-UP

qAttaching the front fork

Required Tools: 13mm open wrench and 5mm Allen wrench

1 Remove the steering bolt and

2 Insert the front fork into the

3 Be sure to properly align slot in

locknut from the frame assembly

frame assembly.

headset tube with pin on fork as

with a 13mm open wrench and

 

shown.

5mm Allen wrench.

 

 

4Re-insert the steering bolt and secure with locknut using a 13mm open wrench and 5mm Allen wrench.

qAttaching the front Wheel

Required Tools: 5mm Allen wrench and 10mm open wrench

1 Remove the four coupling

2 Insert the wheel assembly into

3 Re-insert the coupling bolts

bolts from the front fork with a

the front fork assembly and align

through the front fork and tighten

5mm allen wrench and 10mm

holes. When installing the wheel,

securely.

open wrench.

make sure the letter “F” and arrow

 

 

(located on the side of the wheel)

 

 

are facing the direction as shown

 

 

above.

 

3

WARNING: Failing to properly tighten the steering bolt that attaches the front fork assembly to the frame assembly, can cause you to lose control and fall.

Image 4
Contents Flash RideR Contents Estimated Assembly and Set-Up Time Allow up to 15-20 minutes for assemblyBEfORE yOU Begin Required ToolsASSEMBLy and SET-UP Locknut from the frame assembly Frame assemblyAttaching the front fork Attaching the front WheelAttaching the Seat Attaching the Rear Caster WheelsRequired Tools 5mm Allen wrench SET UP and Usage Instructions Using the Spark HandleReplacing the Spark Cartridge On both sides of the cartridge toFLASH Rider 360˚ Caster TRIkE Parts Front Wheel w/ Pedals and Cranks CompleteSAfETy Reminders WARRANTyPRE-RIDE CHECkLIST Loose Parts Tire Care Frame, fork and Handlebars Safety Gear