Step 3. Rear Wheel Assembly
Turn stroller onto its front as shown (Figure D). Slide the rear axle assembly onto frame as shown (Figure E1). Note: to remove rear axle assembly push up the plastic baffles while pushing in the silver release button pull
off the axle assembly (Figure E2). Place rear brake cog on the rear wheel – turn the cog so the grooves line up with the ribs on the wheel sprocket, then push the adapter on. Slide the wheel with brake cog onto the axle (Figure F1). Place the wide end of the retaining clip onto the grooved end of the axle, then press to snap into place (Figure F2). Posi- tion the axle cap over retaining clip and then press to snap into place (Figure F3). Place the hubcaps on the wheels – align the hubcap tabs with the holes in the center of the wheel, then press into place (Figure F4). Repeat for other side.
Rear Axle
Rear Axle
Assembly
Release
Button
D | E1 | Rear Axle |
|
| Assembly |
Rear Axle
Rear Axle
Assembly
Release
Buttons
Both Sides
E2 |
| F1 |
|
|
|
F2 | F3 |
| Retainer |
| Clip |
Retainer |
|
Clip |
|
Axle Cap
F4
Axle Cap
Hub Cap
3