InStep RS100 manual For Models CS150T, CS200 and CS300, To place child in stroller

To place child in stroller:

Always engage rear brakes so stroller is steady. Lift canopy from both sides and rotate back. Place child in stroller with the T-shield between the child’s legs. Fasten the waist buckle. Adjust belt so that it fits snugly around the child’s waist (Figure L). (Note: To release, squeeze sides of buckle)

WARNING: Avoid serious injury from falling or sliding out. Always use seatbelt.

To adjust 3-position recline seat:

To fully recline seat, pull up on the recline bar as shown. (Figure M) To position seat upright, push back of seat until side tabs fall into side notches.

WARNING: Child may slip into leg openings and strangle. Never use in a reclined carriage position unless T-shield/waist strap have been readjusted to the seats new position.

For Models CS150T, CS200 and CS300

Child’s Convenience Tray

The napper bar must be used when using the child’s tray.

Step 1. Snap the child’s tray onto both side latches as shown (Figure N).

Parent’s Convenience Tray

WARNING: To avoid burns, never put hot liquids in the parent tray. To prevent tipping over do not place more than 3 lb. or 1.4 kg on parent tray.

Phillips screw driver is required for installation.

Step 1. Fold the tray several times in the hinge area to break in the hinge (Figure O1).

Step 2. Align the holes on the tray with knob on frame and snap tray into place over knob. Repeat for other side (Figure O2).

L

M

Tray
Centering	Side
Supports	Clamp

N

O1

Flex

Hinge

O2

Parent Tray

Knob

5