Go-Go Babyz UNIQR manual Attaching to Non- Britax Car Seats

Page 7

Instructions below are for attaching to Non-Britax / Fisher Price Car Seats.

You will use two thumbscrews, the short strap with two cleats attached by two o-rings and the tether strap from the car seat.

1.Place the seat face down on the floor.

2.Align the plate.

Align the two support tabs on the back side of the gogo Kidz plate to the bottom of the car seat and lay the gogo Kidz plate on the back of the car seat. (Please refer to general information if you are having difficulty)

3. Attach the strap.

Begin by securing the end of the strap that has only one grommet to either the left or right side of the gogo Kidz plate. Insert a thumbscrew into the highest hole possible on the plate and thread the thumbscrew into the cleat. The strap should be in between the plate and the cleat. Leave the strap loose because you will tighten it later. Make sure the strap is not twisted. Once one side is attached, thread the strap through the seat belt opening of the car seat.

NOTE: The cleat can be relocated if necessary to fit the needs of your particular car seat. To change the location of the cleat, remove the o-ring that attaches the cleat to the strap. Place the cleat over the proper hole and replace the o-ring.

6. Attach the other side of the strap.

Insert the thumbscrew into the other side of the plate, at the same height as the first side. Begin threading thumbscrew into the cleat. Retighten the first thumbscrew until it is almost flush with the plate Then retighten the second thumbscrew again.

7. Test the connection.

Once the strap is tightened, lift the car seat and gogo Kidz into the upright position and test the connection by pulling on the handle and moving the gogo Kidz side to side. Retighten the strap.

8. Attach the tether strap.

The tether strap is connected to the car seat and attached onto the handle of the gogo Kidz plate (as shown on the general information page).

NOTE: ALWAYS SECURE YOUR CHILD WITH THE SAFETY HARNESS PROVIDED BY THE CAR SEAT MANUFACTURER.

Attaching to Non- Britax Car Seats

Make sure tabs align with ribs at the bottom of the car seat. Use opening if available

Adjusting the cleat on the strap

Leave thumbscrew loose until you begin threading opposite side, and then tighten

ATTACHING THE GOGO KIDS TO A CAR SEAT

7

 

 

Image 7
Contents Gogo Kidz Travelmate Safety & Operating Instructions Express Limited Warranty WarrantyTable of Contents Safety Safety Recommended CAR Seats General Attaching InformationAttaching to Non- Britax Car Seats Attach the versa-tether strap Attaching to a Britax or Fisher Price car seatPlace the seat face down on the floor Insert retainer bar Insert thumbscrewsAirplane Aisles Commercial Airlines, car seats and the gogo Kidz TravelmateCare Maintenance Thank you