Combi Flash EX 655 instruction manual Reference only and may not

Attaching/Releasing Infant Seat	Cosco, Eddie Bauer,	Note: Illustrations are for
		reference only and may not
	Evenflo, Discovery, Peg-Perego
		represent the actual product.

1Use object to press in plastic tabs to release right and left end caps. (See diagram A) The plastic tabs are located underneath the front rail of the stroller on the plastic right and left rail covers. (See diagram 1) Right and left end caps will be released by pressing in plastic tabs. (See diagram B) End caps must be removed to install Cosco Eddie Bauer, Evenflo, Discovery or Peg-Perego infant carrier.

2

2

1

2Unbuckle the attachment strap and lay over the right and left side of the stroller frame.

3Hook the infant seat onto front rail of the stroller. The foot end of infant car seat/ carrier will rest on the two L-shaped brackets.

A

B

Remove End Cap

3Bring the infant seat attachment straps through the seat belt guides in the infant car seat/carrier and fas- ten the buckle. To loosen, tilt the buckle and pull up. To tighen, pull the strap.

WARNING

3	Never use this product without securing the attachment
	strap to the infant seat.

WARNING

The infant harness must be buckled correctly per your manufacturer's instructions.

WARNING

Make sure you tighten the attachment strap before

u sa ge.

REMOVING THE INFANT SEAT/CARRIER

Remove the infant car seat/carrier by reversing the above steps. See your infant car seat manufactu rer's instructions for proper release lever operation.

Trade name and trademarks of Graco® , Century® , Evenflo® and Cosco® and Peg-Perego are the property of their respective owners and no endorse- ment of or approval by them is intended or implied. All Combi Flash EX strollers are compatible with specified models of the Graco® , Century® Evenflo®, and the Peg-Perego®infant car seat/carrier models as of the date this printing was prepared.

Copyright May 2005 Combi USA Inc.

- 6 -