Step 3. Front Wheel Assembly
Turn stroller upright onto its rear wheels and then tip stroller back so that the handlebar is down on the ground and the front fork is up. The front brake Quick Release lever (Q/R), located on the front fender, should be in the open position (Figure C).
C
Brake Pad
Nut
Brake Pads
Closed
Open
Q/R Brake
Lever
Attach the front wheel by loosening the wheel’s quick release (Q/R) lever on the front wheel far enough to allow the axle to slide into the front fork (Figure D). With lever in open position, hand tighten the cone nut until almost tight, then flip lever backward to the closed position to lock wheel in place. Note this step may require minor adjustment until the Q/R lever flips back with firm pressure (Figure E). Pull outward on wheel to ensure it is locked in place.
Close the front caliper brake by lowering the Q/R lever (Figure F). Spin the front wheel to make sure the brake pads do not rub and are properly aligned to the rim. If brake pad alignment is off, loosen brake pad nut with an adjustable wrench, align brake pad and retighten nut while holding the brake pad in place.
WARNING: The interior jam nuts are factory installed and do not need adjustment.
WARNING: Always be sure to
Assembly is now complete!
D
Q/R Lever
Open
Cone | Closed |
Nut |
|
Front Fork
E
Cone
Nut
Q/R Lever
Closed
F
Adjusting
Sleeve
Lock Ring
Q/R Brake
Lever Closed
Brake Pad Nut
3