InStep manual SB100 Assembly Instructions, Stroller Assembly Instructions, Parts List

IMPORTANT

We appreciate your purchase of one of our many fine products. We are sure that you will be satisfied with your selection. We regret that although great care and effort have been taken, occasionally problems may occur. PLEASE DO NOT RETURN PRODUCT TO THE STORE. To ensure prompt and correct handling of problems, or to answer questions, please contact us at either our Toll-Free Customer service Number or Email us at our number listed below. Service will be quicker if you have your model number (found on the product and box) along with this instruction sheet ready when calling. If you have any questions concerning

the safe use of this product, Please contact us 1-800-242-6110 press “1” for customer service and then “2 “to speak to a representative or E-mail us at info@instep.net or visit our web site at www.instep.net

SB100 Assembly Instructions

Parts List

Description	Qty.
Frame assembly with seat, belly bar and headrest	1
Canopy	1
Dual Front wheel assemblies with booties	2
Rear wheel axle assembly	1

Rear	Frame
Wheel Axle	Assembly

Front Wheels w/Booties

Canopy

Stroller Assembly Instructions

Step 1. Unfold Stroller

Push in the handle buttons located on each side of the stroller (Picture A). While holding buttons, grasp handle on each side, lift up so stroller raises off the ground. Shake gently - the stroller will automatically unfold. Continue extending handle until the handle buttons snap into place.

Lift up on the front belly bar until it snaps into place (Picture B). To lower belly bar for storage, push in the latches located on each side of the belly bar (under the material) and then push belly bar down (Picture C). Return belly bar to upright position so it snaps in place.

A

Belly Bar (down position)

Belly Bar Latches (under material

Front

Leg

Handle

Buttons

Rear Leg

C

Belly Bar Latches (under material)

B	Back
Belly	Rest
Bar
Up
Down

Belly

Bar

Latches

2